What is a "Truck Zone" in the United States?
- By
- Aparna Patel
- |
- 25 Jul, 2023
- |
I’ve found your END TRUCK ZONE signs.
This is about a 4.3 mile stretch of I-75 northbound, beginning 31 miles from downtown Knoxville, where trucks are restricted to the right lane. It begins at the end of the Exit 134 interchange, just before milepost 135, with signs reading TRACTOR TRAILER TRUCKS DO NOT PASS, and ends with the END TRUCK ZONE signs perhaps a quarter mile past milepost 139.
After reviewing this entire stretch of highway on Street View, I noticed that the 4% grade signs are on the opposite side of the highway.
The reason for this restriction, then, is that this stretch of road is a steeper uphill than it looks, and trucks would simply be unable to pass safely or without blocking traffic. This would also be why they were going slower than you expected. At the end of this zone it levels out, and trucks can get back up to speed.
From some truckers’ chatter I’ve read, I gather that there are several other spots along I-75 between here and the Kentucky state line where trucks slow down unexpectedly due to steeper than expected grades, though I didn’t go looking for all of them; I figure this example should be sufficient.
If you were in the Knoxville area, it’s possible this was due to a relatively recent (2006) reduction in speed limits for "air quality" reasons which reduce trucks from 70 to 55 MPH, and cars from 70 to 65 MPH.
If you’re going 70, and the truck is going 55, you’ll pass the entirety of a 52′ truck in about 2-2.5 seconds; a 40 mph truck you’ll pass in 1.5-1.8 seconds. So unless you actually speed-checked the trucks, it’s possible they were indeed going 55.
There’s no particular reason for hazards I don’t think, though I don’t know TN law. Illinois has this law for the entire state (trucks maximum speed is 55), and they don’t use hazards here.
Truck zones also often are used to define areas where trucks must use the right lane(s), or more specifically not use the left lane(s), though usually that’s on a 3 lane highway, and indeed TN law allows for that:
55-8-195. Rules and regulations directing truck tractors and semis to specific lanes on certain highways.
(a) The department of transportation is authorized to promulgate rules and regulations directing truck tractors and semitrailers, as defined in § 55-8-101, to specific lanes, as indicated by appropriate highway signage on interstate and multilane divided highways that are three (3) or more lanes in each direction. Rules and regulations promulgated pursuant to this section shall not apply when truck tractors and semi trailers are passing other motor vehicles.
However, if you were on a two lane road, I don’t imagine that is what happened here.
Truck zones also sometimes define areas trucks are allowed to drive in; for example, in my city there are only a few specific streets they’re allowed on (to avoid maintenance and increase safety). Those are more commonly called "Truck routes", but I’ve seen ‘zone’ also used in some places before.
Finally, trucks sometimes are limited in speed due to hilly areas with a steep grade, where it’s not necessarily safe to go at higher speeds for heavy trucks. Those are usually well signed, though, with lots of signs advertising the grade and indicating things like "FIVE MORE MILES OF STEEP GRADE TO GO" and "DON’T RELAX NOW, STILL ANOTHER THREE MILES OF 8° GRADE" and such.
- Are backpack nets an effective deterrent when going to rougher parts of the world?
- London on Christmas Day
Credit:stackoverflow.com‘
Search Posts
Latest posts
-
4 Mar, 2024
Can I accidentally miss the in-flight food?
-
4 Mar, 2024
Why are there no seat belts on trains?
-
5 Mar, 2024
How to avoid drinking vodka?